KARL DENVER 45 LONDON 9534 VG/VG+ DJ USKA DARA ZIMBA
$
26
$ 26
Sold For
Jan 17, 2010
Sold Date
Jan 10, 2010
Start Date
$ 10
Start price
3
Number Of Bids
USA
Country Of Seller
eBay
Auctioned at
Favourite Auctions
To save auctions to your favourites, please login
If you don't have an account, please register
Description
wrigley Store
KARL DENVER 45 LONDON 9534 VG/VG+ DJ USKA DARA ZIMBA
Search
KARL DENVER 45 RPM ....DJ / PROMOTIONAL 45.... ORIGINAL: LONDON 45-LON 9534 DJ 45 rpm TRAIL-OFF/DEAD WAX INFO: DR29026-1C 8-2 5-62 / DR27968-1C 8-1 5-62 FORMAT: MONO YEAR: 1962 CONDITION (Please see grading table below for definitions): ***THIS 45 rpm IS PLAY-GRADED***
- 45: VG/VG+ (light scuffs/scratches....plays nicely on my Denon with light pops in spots)
- LABEL: VG (rubs; small writing both sides...see photos)
- USKA DARA
Side 2 (DRF 27968):
- ZIMBA
RECORDS:
- Sealed: Store stock new
- Mint: Like new or near new with only one or two small insignificant defects
- Near Mint/M-: Extremely nice. Would be Mint, except for a possibly a couple of light hairlines or scuffs
- VG++: Still a very nice record with all or nearly all of its original gloss but may have a few more light, surface marks, hairlines, needle tracks or the like
- VG+: A nice, but used record that may have a series of light scuffs or scratches. It probably plays with a some pops
- VG: A well-used record that still should sound OK when played, but may have moderate surface noise, pops, and even a possible skip.
- VG-: A very well-worn record that plays through, probably has skipping and snap, crackle, pop
- Good: Probably will play through but with much in the way of surface noise, pops, crackles, skips etc.
- Fair: You’re getting this record just to own.
- Poor: The sky’s the limit as far as condition in the negative sense
- I will give greater weight to the condition of the front cover than back cover when assigning an overall grade
- Stickers – I will state if there are any
- If I write that a cover has a punch-hole, I’m talking about a small punch-press type hole
- A factory saw mark is a narrow cut in the perimeter of the cover, could be anywhere and vary in length from 1/2” to 2” at the most.